Scooter Upgrade Kit Basic Edition

Is your scooter due for an enhancement? Opt for a superb custom trick scooter featuring a threadless headset, one-piece T-bar, compression system, and two lightweight single clamps!

We've curated a kit of five components designed to upgrade the following threaded scooters. The kit transforms your threaded scooter into a threadless one using ICS compression technology.
A trick scooter equipped with compression spins more smoothly and is easier to tighten, with the one-piece bar offering added strength.

The kit comprises:
1x District Pro Threadless headset
2x District single clamp (32mm & 35mm)
1x Worx Royal Bar black one-piece T-bar (Alu. 35 mm outer)
1x Worx Royal pro scooter fork black threadless pro scooter fork
1x Worx compression kit.
Note: Grips are available separately; all grips fit this bar.

Scooters eligible for an upgrade with the kit:

• JD Bug Pro Scooter
• Razor Pro XX Scooter
• Razor Ultra Pro Lo Scooter
• Roces Kook Trick Scooter
• Slamm Rage Urban
• Grit Extremist Scooter
• Micro Bullet Street Pro 2.0 Scooter
• Grit Extremist Pro Scooter
• Madd Flow Scooter
• Micro Trixx scooter
• Razor Black Label 3.0 Scooter
• Razor Pro III Scooter
• Madd VX2 Pro 2012
• Razor Black Label 4.0 Scooter
• Madd VX2 Team Edition 2012
• Micro MX Park scooter

Also compatible with:

• Slamm Mischief
• K2 Park Pro Scooter
• Shaun White Trick scooter
• Grit Elite Scooter
• Micro MX Pro OPB Scooter
• District V4 Complete scooter
• Lucky Crew Scooter
• Madd MGP Ninja Scooter
• Madd MGP Ninja 2012 Scooter
• Madd Nitro End of Days 2012
• Madd Nitro Extreme Scooter

*Other scooters may also be compatible for upgrading
*Handlegrips are not supplied; feel free to use your existing ones or purchase a new set (all are compatible).
*Necessary tools: Screwdriver+Hammer+Tape measure+Unbrako key along with a bit of mechanical skill ;)
-----------------------------------------------------------------------------------------------------------------------------------
Instructions:
Basic trick scooter assembly knowledge is required. We suggest reviewing our guide before commencing. Read Assembling a custom scooter here.
Upon receiving the kit, first clean your old scooter and detach the old headcups from the headtube.

1. Use a screwdriver to remove them and a hammer to install the new ones. Place a wooden block in between to prevent scratching the deck or new headcups.
2. Fit the headset bearings into the new headcups.
3. Next, gauge how far the new pro scooter fork extends into the bar, from the top of the headset up to the starnut, which is pre-installed inside the bar.
4. Ensure the compression bolt can attach to the starnut to streamline the entire system. If the starnut isn't sufficiently elevated, use a screwdriver to position it deeper. Should the starnut be too high within the bar, utilise the included replacement starnut.
5. Adjust the compression until it spins to your liking.